In this post, I am going to tell more about control box of ARFCNC 6090.
1, ARFCNC 6090 Mach3 motion control box structure
a. Physical cable connection method
b. Spindle socket connection method
2. ARFCNC 6090 Mach3 USB Control box Schematic
3. XHC Mach3 USB Motion Control Card Schematic
Nowforever E100 VFD wiring diagram
Diagnostics(Alt-7) in Mach3
4. Stepper driver Input&Output Voltage Terminals breakdown
a. Red/Black Input 24VDC: GND and Vdc terminal can NOT be reversed. Otherwise, stepper driver will be burned.
b. How to measure Stepper driver Input Voltage?
c. How to measure Stepper driver Output Voltage?
5. How to Measure Power Supply ?
1.How to verify Mach3 XHC USB Motion controller input signals?
A: The simple way is to use jumper wire below to short curcuit 0V and input pins(X-home, Y-home,Z-home,Probe, E-stop)
Will it lid corresponding led in Alt-7 tab(Mach3)?
2. The spindle can NOT turn on and VFD panel show error code.
A:Please follow below steps to check spindle and belongings.
without spindle cable connected, what does VFD panel show? still error code?
2) Spindle cable
a.Measure point 1,2,3 from connector of two side, is it connected?
b.Check physical connection as above(point 1)
a.Spindle good shape no deform?
b.Spindle generate sound eg. chirp or just no response/no any sound?
c. Is it hold down bracket too tight? loosen it a bit.
4) Control box internal connection
a. U/V/W terminal(VFD side) loosen?
b. spindle socket(control box side) bad connection? (see attached) use multi-meter
3. My machine has photocell sensors, but it won’t stop machine. What is the problem?
1.Please firstly make sure Mach3 motion card is good working in question 1.
2.With multi-meter on your hand, measure photocell sensor(NPN) voltage as below.
lines of photocell sensor
brown(red) line is 24VDC+
blue line is VDC-
black line is singal
switch to 200VDC gear
Red probe for voltage and Black probe for COM
Mach3 motion card side
Red probe for 24VDC and Blace one for Z home(or X/Y home)
photocell NOT lit up it is 0.05 or something very small
photocell lit up it is 23.9 or something close to 24V